The SPL 2Control Analogue Monitor Controller has a unique Crossfeed control that allows you to judge a stereo panorama on headphones, just like with loudspeakers.
The concept of the SPL 2 Control is based on a dual-channel operation that allows for connection of two sources, two stereo speaker sets and two headphones. Each of the three speaker outputs (2 stereo sets, 1 x mono speaker) is driven by its own balancing stage to exclude signal degrading mutual influences. Each headphone output is supplied by a separate amplifier to allow for completely independent operation of two headphones without any interaction from the other output.
A new feature of the 2Control is the Crossfeed control for both headphone outputs, which was derived from the high-end headphone amplifier Phonitor. From their principle, headphones have the disadvantage of producing a 180 degree stereo panorama – the Crossfeed control can be used to adjust a stereo panorama that corresponds to a stereo speaker image.
The SPL 2Control Analogue Monitor Controller Main features Include:
Two channels, Two sources, Two loudspeaker sets, Two headphones
Analog volume control for your DAW
Two excellent headphone amplifiers
Crossfeed control
Extend the range of headphone applications
High-grade balancing stages
Unbalanced connection (e.g. RCA, TS Jack)
Separate mono speaker output
Input sockets: XLR
Output sockets: XLR, Stereo TRS
Nominal input level: IN 1: +4dBu, IN 2: +4dBu/-10dBV
Input impedance: 22kOhm
Output impedance: 75Ohm/Headphones: 22Ohm
Max. input level: 21,3dBu
Max. output level: 21,3dBu
Volume control range: -80dB to +6,6dB
Headphones: -65dB to +14,9dB
Frequency range: 10Hz to 100kHz (-3dB)
CMRR: ›60dB (@1kHz, 0dBu input level, unity gain)
THD: 0,002% (@1kHz, 0dBu input level, unity gain)
Signal to noise ratio: -96dB/Headphones: -85dB (A-weighted)
Crosstalk L/R: ›70dB (@1kHz)
Dynamic range: 116dB
Power consumption: ca. 25W
Features: Toroidal transformer with voltage selector
SPL MTC Mk2
Heritage Audio RAM System 2000
SPL Marc One
SPL Control One